Energy Figures

Australia

Property report Queanbeyan-Palerang, NSW

Not graded: protected area

Sources: Geoscience Australia, Global Solar Atlas, CSIRO, ABARES Updated 14 Oct 2026 Sources and methods

Add lot 127//DP754887Add lot 2//DP511559Add lot 174//DP754887Add lot 15//DP882788Add lot 2//DP573146Add lot 20//DP754887Add lot 3//DP560403Add lot 163//DP754887Add lot 201//DP1277208Add lot 14//DP1331275Add lot 2//DP700937Add lot 155//DP754887Lot 2//DP560403Lot 202//DP1277208Lot 85//DP754887Lot 89//DP754887Best site2.5 km

AREA 703 HALOTS 4

Cadastre © State of NSW (Spatial Services), CC BY 3.0 AUYour propertyNeighbouring lot, tap to addBest and typical sites
Lots in this property (4)
Lots in this property
Lot/planAreaRemove
2//DP560403Area: 94 haRemove 2//DP560403Remove
202//DP1277208Area: 48 haRemove 202//DP1277208Remove
85//DP754887Area: 16 haRemove 85//DP754887Remove
89//DP754887Area: 545 haRemove 89//DP754887Remove

Add a neighbouring lot

Neighbouring lots
Lot/planAreaAdd
127//DP754887Area: 889 haAdd 127//DP754887Add
2//DP511559Area: 409 haAdd 2//DP511559Add
174//DP754887Area: 291 haAdd 174//DP754887Add
15//DP882788Area: 172 haAdd 15//DP882788Add
2//DP573146Area: 145 haAdd 2//DP573146Add
20//DP754887Area: 133 haAdd 20//DP754887Add
3//DP560403Area: 91 haAdd 3//DP560403Add
163//DP754887Area: 73 haAdd 163//DP754887Add
201//DP1277208Area: 72 haAdd 201//DP1277208Add
14//DP1331275Area: 59 haAdd 14//DP1331275Add
2//DP700937Area: 51 haAdd 2//DP700937Add
155//DP754887Area: 32 haAdd 155//DP754887Add

Grid

Farther from the grid than most operating farms

Nearest substation, best site
26 km
Bungendore 66 kV substation. Median farm 3.2 km. 23 km from the property's edge.
Nearest line, 66 kV or more, best site
21 km
66 kV. Median farm 0.8 km. 19 km from the property's edge.

Land and sun

Steeper than most operating farms

Slope within 500 m, best site
12.3°
Steeper than every operating solar farm (median 0.8°). Across the property 0.6° to 28.9°.
Full sun a day, best site
4.3 h
Less sun than 98% of operating solar farms (median 4.7 hours a day)

Land use by area

National park
542 ha, 77%
Grazing modified pastures
119 ha, 17%
Grazing native vegetation
40 ha, 6%
Other
1.0 ha, under 1%

Farms nearby

5 within 50 km of the property's edge.

2 more within 50 km

Hear if developers start looking for land near here

Questions

How is the property compared with built solar farms?

Site by site, measured the way the farms are. The property is split into sites the size of a solar farm, circles of 500 m radius, each wholly inside the lots. Each site is measured as each built farm is at its centre: straight-line distance to the nearest substation and to the nearest 66 kV or higher line, solar yield at the centre, and average slope within 500 m. Each site is graded as the land check grades a point, against Australia's operating solar farms of 5 MW or more, with the property's own area: under 20 ha the grade is at most C, and over 300 ha the site is also compared with farms of 100 MW or more. The property isn't graded when half or more of it is protected, built up or water, or when its edge is more than 100 km from a substation. The best site is the one with the best grade, then the closest to the grid and flattest overall; the typical site is the middle one. A lot too small for one site is measured at a point inside it.

Why is the distance from the edge shorter than from the best site?

A large property reaches farther, so its nearest edge is closer to things than any one site on it. The ranking uses sites, measured as built farms are; the edge distance is shown beside it.

How is the whole property measured?

Solar yield and slope are averaged over every grid cell whose centre falls inside the lots: cells of about 1 km for yield and about 90 m for slope. A property smaller than one yield cell takes the value at its centre. Land use is the area of each class at 50 m. The slope bands are plain bins, not a judgement.

Where do the lot boundaries come from?

NSW lots: cadastre © State of NSW (Spatial Services), CC BY 3.0 AU. Queensland lots: the Digital Cadastral Database © State of Queensland (Department of Resources), CC BY 4.0. Each lot is read when first asked for and kept for 30 days. Lots within 60 m of the property, across a road for example, are offered as adjoining lots. A lot is a parcel of land, not a title or an owner: no ownership details are read or shown.

Where do the addresses come from?

From each state's own address service, read when you search: NSW Spatial Services, Queensland's address database and Vicmap Address. Addresses: © State of NSW (Spatial Services), CC BY 3.0 AU; © State of Queensland (Department of Resources), CC BY 4.0; Vicmap Address © State of Victoria, CC BY 4.0. Towns: ABS Suburbs and Localities 2021, CC BY 4.0.

Why only NSW and Queensland?

Property selection covers NSW and Queensland so far, whose cadastres can be read openly lot by lot. Everywhere else the land check works by point. Address search also covers Victoria.

Is this property stored?

Each report stores its lot numbers, the result and the date, at the property's centre rounded to about 100 m. If you answer the hosting question, that is saved with it. See the privacy page.